Technical Support
103 engine installation reverse gear
Both gaskets should be coated with sealant to prevent oil leakage
107-117 engine installation reverse gear
Both gaskets should be coated with sealant to prevent oil leakage
2: When reversing normally or on a slope with high rear wheel position, you can hold the front brake, then hold down the start button and hold it, and then release and hold the front brake to achieve a start stop observation while reversing mode.
warning
The only way to exit reverse gear during use is to hold down the front brake to
make the vehicle stationaryo When reversing onaslope or uneven road,in order to ensure a smooth exit from reverse gear, it is necessary to use 1.5 times the usual force to hold down the front brake to prevent the reverse
gear from being bitten. At this time, shifting to forward gear may damage the safety copper pin inside
the reverse gear!
3: The neutral switch must be functioning properly, and the green N light on the instrument panel must light up normally when in neutral position.
Function settings
1: Reverse voice prompt can be turned on or off， by turning on the ignition switch, not starting the engine, holding the front brake and simultaneously holding down the left turn signal for more than 5 seconds
2: Turn on and off the cooling fan, turn on the ignition switch, do not start the engine, hold the front brake and hold down the right turn signal for more than 5 seconds to turn on or off the cooling fan. After turning on the cooling fan, the ambient temperature must reach 28 degrees Celsius, the engine temperature must be 55 degrees Celsius, and the vehicle speed must be below 15km/h to start running.
3: Ladies’ concern, for women and some riders who may feel that the reverse speed is too fast, which may affect reverse safety, you can select reverse high and low gears by holding the front brake and simultaneously holding down the left and right turn signal switches for more than 5 seconds.